This Megalodon Sharks Tooth is a very high quality, jet black tooth that is 3" in height, and 2 1/2" in width.

To give you an idea of how the bolo tie will look like, the tooth is shown on a 8 ply black leather bolo cord. A sterling silver frame will be added to the tooth when I fabricate the bolo tie.

This bolo tie is a tall man's tie! A person that is about 6 ft 6 inches.

The Sterling Silver bolo will be about 3 1/2" in height and about 3 inches in width,
and the bolo cord will be about 56 to 58 inches in total length.

The above picture on the left shows the tooth serration detail.
The above picture on the right shows the style of Sterling Silver frame that will be used.
The outside border will be a very heavy gauge hammered flat twist wire, about 1/4" in width.
The Sterling Silver back plate will be a heavy gauge plate for mounting the twist border and
the dual loop bolo slide.

The bolo tie will have a 8 ply black leather bolo cord with a braided neck section, top left picture.
The bolo cord will be extended in length with the Sterling Silver reticulated splice tubes,
top right picture, and will have heavy Sterling Silver reticulated tube tips, see top center picture.
The cord length between the tube splice and the tube tips is about 6 inches.

Allow 6 weeks for fabrication and delivery.

The Megalodon Shark Teeth are from the South Carolina rivers which cut through the fossil-rich
Hawthorne Formation. The largest teeth are about 7 inches in height.